Instructions
Intended Use
This device is intended for medical purposes to illuminate body surfaces.
It is used for non-invasive visual examination of intact skin.
This battery-operated product is designed for external examination only
within professional healthcare facilities by medical professionals.
Check the correct operation of the device before use! Do not use the
device if there are visible signs of damage.
CAUTION: Do not look directly into the LED light. Patients must close
their eyes during examinations.
In case of a serious incident with the use of this device, notify 3Gen
immediately and, if required by local regulations, your national health
authority.
CAUTION: Do not use the device in fire or explosive risk area (e.g.
oxygen-rich environment).
CAUTION: This product contains magnets. Do not use in proximity of
pacemakers or other magnetically sensitive devices or items.
WARNING: This product can expose you to chemicals including methy-
lene chloride and hexavalent chromium, which are known to the State of
California to cause cancer or reproductive toxicity. For more information
go to www.P65Warnings.ca.gov.
Electromagnetic Compatibility
This device complies with the EMC Emissions and Immunity level re-
quirements of the standard IEC 60601-1-2:2014. The emission character-
istics of this equipment make it suitable for use in professional healthcare
environment as well as residential environment (CISPR 11 Class B). This
equipment offers adequate protection to radio communication service.
In the rare event of interference to the radio communication service,
the user might need to take mitigation measures, such as relocating or
re-orienting equipment.
WARNING: Use of this equipment adjacent to or stacked with other
equipment should be avoided because it could result in improper oper-
ation. If such use is necessary, this equipment and the other equipment
should be observed to verify that they are operating normally.
WARNING: Use of accessories other than those provided by the man-
ufacturer of this equipment could result in increased electromagnetic
emissions or decreased electromagnetic immunity of this equipment and
result in improper operation.
WARNING: Portable RF transmitters should be used no closer than 30
cm (12 inches) to any part of the device. Otherwise, degradation of the
performance of this equipment could result.
IMPORTANT: Before initial use, please charge the internal lithium ion
battery. See "Battery and Charging" for details.
DermLite Foto II Pro is a dermoscopy lens designed to let you capture
high-resolution dermoscopic images with any Canon or Nikon SLR.
Directions for Use (Fig. 1-5)
Fig 1. The device is ready to be used with Nikon SLR cameras. For use
with Canon cameras, detach the installed F-MOUNT adapter and replace
it with the EF-EF-S adapter, making sure the alignment pin (AP) is seated
in its mating hole.
Carefully place the device with the faceplate (FP) onto the skin. Fig. 2:
To activate the unit in polarized mode, push on the X button. To activate
non-polarized illumination, push it again. You may change the field-
of-view by rotating the zoom ring (ZR) to either the fully zoomed-in or
zoomed-out position; avoid a midrange zoom setting as this may result
in out-of-focus images. The numbers on the zoom ring indicate image
frame height in mm for both full-frame sensors as well as cameras with a
smaller sensor size.
The device captures images with a very shallow depth of field which
enables precise focusing on the area of interest. The focus ring's (FR) "0"
mark has been factory-calibrated to result in sharp images in most cases.
To make fine focus adjustments, activate the "Live View" mode on your
camera, if available, then digitally zoom in using your camera controls
while turning the focus ring (FR) one marking to the right or left.
Fig. 3: By attaching the flash sync cable (FC) as shown, the device will
automatically change polarization mode after each photo.
Fig. 4. Zoom lock (ZL): In order to achieve repeatability, you may lock the
zoom ring using the included hex key. Simply remove the adapter ring
(AR), turn the key as shown, then reattach the ring.
Fig. 5 The spacer (SP) and faceplate (FP) are attached magnetically and
may be easily removed for cleaning. To turn off the unit, push and hold
the button for about 1 second.
Battery and Charging
CAUTION: This device uses a special 3.7V 1480mAh (2pcs) lithium ion
battery, which can only be purchased from 3Gen or from an authorized
3Gen dealer. Do not under any circumstances use another battery other
than the one designed for this unit.
This device is equipped with a battery indicator (CI). When the unit is
turned on and fully charged, the indicator lights up green; when less
than 20% of battery life remains, the indicator is orange while a red glow
shows that less than 10% of battery life remains. To charge your device,
connect the supplied Micro-USB to USB cable to the Charging Port (CP)
and any IEC 60950-1 compliant (5V) USB port. The battery indicator
glows red to indicate charging. When charging is complete, it illuminates
green. From a full charge, the device will allow approximately 2-4 hours
of operation.
After years of use, you may wish to replace the battery, which is only
available from 3Gen or an authorized 3Gen dealer. To change the bat-
tery, contact 3Gen or your local 3Gen dealer.
Troubleshooting
Please check www.dermlite.com for the most current troubleshooting
information. If your device requires servicing, visit www.dermlite.com/
service or contact your local 3Gen dealer.
Care and Maintenance
CAUTION: No modification of this equipment is allowed.
Your device is designed for trouble-free operation. Repairs shall be made
only by qualified service personnel.
Cleaning
The exterior of your device, except the optical parts, may be wiped clean
with isopropyl alcohol (70% vol.) prior to use on a patient. The lens
should be treated as high-quality photographic equipment and should be
cleaned with standard lens cleaning equipment and protected from harm-
ful chemicals. Do not use abrasive material on any part of the equipment
or immerse the device in liquid. Do not autoclave.
DermLite Foto II Pro includes:
Foto II Pro unit with removable spacer and faceplate, USB cable, Nikon
and Canon adapter rings, flash sync cable, international charger.
Warranty: 2 years for parts and labor. The battery is warranted for 1 year.
Disposal
This device contains electronics and a lithium-ion battery that must be
separated for disposal and may not be disposed of with general house-
hold waste. Please observe local disposal regulations.
Technical Description
Visit www.dermlite.com/technical or contact your local 3Gen dealer.
ENGLISH