Cembre B500 Manual De Uso Y Mantenimiento página 11

661 bar P = 661 bar
m
NR 13AJ002
485 bar
min.
max.
The capacitive menu selection button may not work if touched using objects or
BATTERY BATTERY
when wearing gloves, therefore always operate it using a bare finger.
4.2)
SELECTION SCREENS: control parameters that cannot be set as automatic upon
start-up of the tool, can be changed by operating the touch button:
Enabling/disabling the LED Worklights (factory setting LED ON)
LED
BATTERY 
ON

LED
OFF
BATTERY
Return to original factory settings / firmware version
20001

When the "RESET" screen is displayed, return the tool to its factory setting by operating

the touch button for at least 3 seconds; a beep will confirm the setting.
RESET
SW:S1J41AH
4.3)
WARNINGS: these appear during operation and notify the operator of the status
of the tool:
LED
OFF
BATTERY 
LED

ON
BATTERY
20001


RESET
SW:S1J41AH
11
B500
All manuals and user guides at all-guides.com
OK
To make a selected screen operational and appear at each start
up of the tool, operate the touch button for at least 3 seconds; a
3 SEC. continuous beep will confirm the setting.


The RESET screen also shows the firmware version of the circuit board.
LOW BATTERY: replace the battery.
NOTE: when the battery Vage falls below a minimum safety threshold,
the tool will not start; although it is still possible to end the work cycle
in progress.
BATTERY TEMPERATURE HIGH: remove the battery and wait until it cools
down.
NO. OF CYCLES TO MAINTENANCE REACHED:
the tool continues to work however, it is recommended that it is sent to
Cembre for a complete overhaul (see § 6).
NOTE: this message, together with a beep, will reappear when the tool
has been idle for 30 seconds.
BATTERY
20001


RESET
SW:S1J41AH
LED

OFF
ERROR

LED
ON

001


002


003


004


ERROR


001


002


003


004


When the screen is dis-
played, touch the button for
at least 3 seconds to deacti-
vate for reactivate operation
of the LED Worklights during
tool use; a continuous beep
will confirm the setting.

001


002


003


004
