Cembre B500 Manual De Uso Y Mantenimiento página 8

NOTE: To display the momentary force or pressure
during the work cycle, select the appropriate display
from the menu (Ref. to § 4). When the operating
button is released before the motor stops automati-
cally, the display will show the peak force (Fp) or the
peak pressure (Pp) reached at that instant.
To complete the work, press the operating button again until the motor stops automati-
cally; the display will show the maximum force or pressure reached followed by "OK" to
confirm correct operation.
The display "ERROR", combined with a beep and the LEDs flashing,
= 60.0 kN
F
m
indicates an incorrect crimping procedure caused by the work
= 58.3 kN
p
cycle being interrupted before the control parameters (force/pressure)
of the tool are reached.
= 661 bar P
m
This error appears when the pressure release button has been operated and the tool has
= 485 bar
p
already reached a pressure >100 bar. In this case, repeat the compression by pressing and
holding the operating button until the motor stops automatically.
max.
2.4) Release of dies
By operating the pressure release button (5) (Ref. to Fig. 4), the ram will retract and open
BATTERY
the dies.
2.5) LED Worklights
Whilst the tool is in operation, the compression area is illuminated by two high luminosity
LED Worklights that switch off automatically at the end of the cycle.
The LED Worklights can be disabled by following the procedure described in § 4.2.
LED
ON
2.6) Head rotation
For ease of operation, the tool head can rotate through 180°, allowing the operator to
LED
work in the most comfortable position.
OFF
Do not attempt to rotate the head when the hydraulic circuit is pressurised.
2.7) Capacitive touch button for menu selection
This button is located under the display and allows selection of
various screens (Ref. to § 4); it only works when the display is on.
Wearing gloves or using other objects may inhibit the operation of
the button, therefore use a bare finger to apply only a light touch.
Do not apply pressure to or stab at the touch button, a light touch using a bare
finger is sufficient. The command pulse is sent when the finger releases the button.
All manuals and user guides at all-guides.com
F = 60.0 kN
m
Fp = 24.5 kN
F = 6.75 ton
m
Fp = 2.75 ton
= 60.0 kN
m
OK
P = 661 bar
m
Pp = 312 bar
= 661 bar
m
OK
P = 9587 psi
m
min.
Pp = 4525 psi


BATTERY
BATTERY
1000
-19000
B500
NR 13AJ002
3 SEC.
F = 60.0 kN
m
F = 58.3 kN
p
P = 661 bar
m
P = 485 bar
p
max.
BATTERY
BATTERY 

BATTERY
20001


RESET
SW:S1J41AH
LED
OFF
LED
ON
F = 60.0 kN
m
OK
P = 661 bar
m
OK
min.


BATTERY

ERROR


F = 60.0 kN
001
m
Fp = 24.5 kN
LED


ON
002
F = 6.75 ton
m

Fp = 2.75 ton
LED

OFF
003
P = 661 bar
m

Pp = 312 bar 
004
P = 9587 psi 
m
Pp = 4525 psi
BATTERY
1000
-19000
B500
NR 13AJ002
3 SEC.
8