Publicidad
Step 10
Carefully turn your unit over onto its front edges. Unfold the
å
BACK (F) and lay it over your unit.
Make equal margins along all four edges of the BACK (F). Push
å
on opposite corners of your unit if needed to make it "square".
Fasten the BACK (F) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over
å
the UPRIGHT (C).
NOTE: The cut out squares must be toward the TOP (D).
å
www.sauder.com/services
These holes must line up
over the UPRIGHT (C).
F
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
415520
1N
NAIL
(48 used in this step)
Cut-out square
D
Page 15
Publicidad
