Publicidad
Step 4
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into
å
the ENDS (A and B) until the shoulder of the SCREWS
rest on the surface of the ENDS.
Slide the END MOLDINGS (O) onto the ENDS (A and B).
å
Line up the groove in the MOLDINGS over the head of the
SCREWS in the ENDS.
These edges
should be even.
www.sauder.com/services
A
O
BLACK 9/16" FLAT HEAD SCREW
(4 used in this step)
B
Shoulder
32S
415520
These edges
should be even.
O
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
Page 9
Publicidad
