Vision Fitness T600E Manual Del Usuario página 7

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 43
Open HARDWARE FOR STEP 3.
3
Attach LEAD WIRE (4) to CONSOLE CABLE (5) and pull lead wire through RIGHT
CONSOLE MAST (6). After pulling the lead wire through the mast, the top of the
console cables should all be connected to the correspondent ports in area (14).
Detach and discard lead wire.
Attach CONSOLE BASE (9) to CONSOLE MASTS (3 & 6) using 4 BOLTS (G), and 4
CURVED WASHERS (H).
Tighten all bolts from steps 1–3.
Install MOTOR COVER (1) using 2 pre-installed SCREWS (A).
Hardware For Step 3
Description
Qty
G
Bolt
4
H
Arc Washer
4
9
1
A
3
5
4
H
6
G
14
Open HARDWARE FOR STEP 4
4
Remove 2 pre-installed SCREWS (L) and detach SERVICE COVER (12).
Carefully tuck all Cables (4) into the CONSOLE (11).
Attach the CONSOLE (11) to the CONSOLE BASE (9) using 4 BOLTS (I) and 4
SPRING WASHERS (J) and 4 FLAT WASHERS (K).
Connect all Cables (4) to the correspondent ports in the CONSOLE (11).
Install SERVICE COVER (12) using 2 pre-installed SCREWS (L).
Hardware For Step 4
Description
Qty
I
Bolt
4
J
Spring Washer
4
K
Flat Washer
4
L
12
K
J
I
9
11
4
7

Publicidad

Tabla de contenido
loading

Tabla de contenido