Service And Maintenance; Adjustments; Gas Conversion - Ferroli BLUEHELIX MAXIMA Instrucciones De Uso, Instalación Y Mantenimiento

3. Service and maintenance

3.1 Adjustments

Gas conversion

The unite can use gas of the 2
plate. If the unit has to be used with a gas other than the factory-set one, proceed as follows:
1. Disconnect the power supply and turn off the gas.
2. Remove the front panel (see *** 'Opening the front panel' on page 213 ***).
3. Turn the Throttle (fig. 24) according to the position indicated in table 7.
4. Apply the plate for LPG (contained in the document bag) near the technical data plate.
5. Refit the front panel and turn on the power to the boiler.
6. Modify the parameter for the type of gas:
• Access the user menu
• Access the [
• Enter the password "1234" and confirm [
• Select [Combustion Control]
• select the parameter [1/Gas type selection]
• Choose the correct type of gas according to table 7 then, from the menu, select the corresponding parameter
[NG/LPG]
• Press [OK]
• Confirm the parameter change by touching [Confirm]
• Exit the service menu by touching the Home icon
• The fan will start for about 20 seconds
• Open the gas
7. MAKE SURE THE FRONT CASING IS CLOSED AND THE INTAKE/FUME EXHAUST DUCTS ARE COMPLETE-
LY ASSEMBLED
Put the boiler in heating or DHW mode for at least 2 minutes. During this period the boiler performs a calibration and
the flame symbol flashes on the display. The end of calibration is indicated by the flame symbol steady on the dis-
play.
Check the combustion values (see following par.).
Table 7- THROTTLE position and parameter setting
Gas family Gas type
G20 - G25 - G27 - G25.1 - G25.3
nd
2
G230
nd
2
G30 - G31
rd
3 family
204
nd rd
or 3 family as clearly indicated on the packaging and on the unit's technical data
service menu] and press confirm
cod. 3541U630 - Rev. 00 - 07/2020
BLUEHELIX MAXIMA
]
Throttle position
1
1
2
1 1
2
fig. 24
Parameter
NG
LPG
LPG
2
EN