Ferroli BLUEHELIX MAXIMA Instrucciones De Uso, Instalación Y Mantenimiento página 218

Fault code Fault
Limit thermostat fault with
F50 - F53
parameter b06 = 1 or 4
Calibration fault
F57 - A56
Calibration procedure not
completed
Controller fault
F58 - A61
Controller fault
A54 - A55 - A63
F67
BCC Service key error
F65 - A68
No communication between
A62
controller and gas valve
Maximum number of consecu-
A64
tive Resets exceeded
F66
218
BLUEHELIX MAXIMA
Possible cause
No/poor water circulation in the
system
Air in the system
Incorrect parameter
Incorrect parameters
Electrode damaged or not
correctly positioned.
Recirculation of fumes inside
the boiler
Poor primary circuit circulation
or poor dissipation during cali-
bration
Controller internal error
Controller internal error
BCC Service key connected
Error loading BCC Service key
file
Controller not connected
Valve damaged
Maximum number of consecu-
tive Resets exceeded
Firmware not loaded success-
fully
cod. 3541U630 - Rev. 00 - 07/2020
Cure
Check the circulating pump
Vent the system
Check the correct parameter setting
Check parameters and carry out a 100% cali-
bration
Check the position of the electrode, replace it if
necessary. After replacement, repeat the 100%
calibration
Check the tightness of the flue pipe and the seal
of gaskets
Reset the fault. Turn on the hot water faucet and
wait for the flame to stop flashing (about 2 minu-
tes)
Check the ground connection.
Check the electrode.
If necessary replace the control unit.
Try disconnecting the power supply to the boiler
for 10 seconds and replace the controller if
necessary
Load the parameters
Repeat the loading procedure within 5 minutes
from the boiler power supply and replace the
BCC Service key if necessary
Connect the controller to the valve
Check the wiring
Replace the valve
Turn off the power to the boiler for 60 seconds
and then reinstate the boiler
Reload the firmware or replace the card
EN