Stopping The Engine - GGP ITALY P680 Manual De Instrucciones

EN 10
In case the brake is not effective, ask our dealer
for inspection and repairs.
If the engine keeps rotating at high speed with
the brake engaged, the clutch will overheat
causing trouble.
When the brake engages during operation,
immediately release the throttle lever to stop the
engine.
• ICING PREVENTION SYSTEM
This system prevents icing of the carburetor
which sometimes happen while sawing in winter.
When your saw has stopped or slowed down
abruptly, use the system as follows:
1. Remove the air cleaner cover, air filter, and
silencer.
2. Unhook the hatch on the rear wall of the cylin-
der cover and turn it upside down.
3. Install the covers as they are.
WARNING!
!
Never use the system in
normal temperature because that can cause
starting failure due to overheating of the car-
buretor.
All manuals and user guides at all-guides.com
(1) Cylinder cover
(2) Air cleaner cover
(3) Intake silencer
(4) Air filter
(1) Hatch
5. Operating the Engine
• ANTI-FREEZE KIT
For use under extra cold condition. Optional
parts as shown right are available. When normal
air filter is frozen even with the hatch opened,
contact your nearest dealer for the anti-freeze kit
parts.

• STOPPING THE ENGINE

1. Release the throttle lever to allow the engine
to idle for a few minutes
2. Set the switch to the "O" (STOP) position.
(1) Air inlet plug
(2) Nylon-net type air
filter
(3) Cylinder cover for
cold use
(1) Switch