Click-To-Link - SCHUBERTH SRC‑System Guía De Usuario

10. CLICK-TO-LINK

Click-to-Link is the spontaneous "social" nature of your SRC‑System™.
This unique feature will enable you to instantly initiate one-to-one
intercom calls with other SRC‑System™ users in the near vicinity without
going through a pairing process in advance. Think of it as a private bike-
to-bike channel that you can set up on-the-fly with other SRC‑System™
users that you spot next to a traffic light or along the road.
The Click-to-Link feature can of course be disabled at any time, blocking
any attempt by other users to establish a spontaneous link.
USING CLICK-TO-LINK
Disable/enable Click-to-Link: The feature can be turned on or off
via the Settings Customization menu (see Section 4.2). By default,
this feature is DISABLED.
AUDIO SOURCeS AND PRIORItIeS
The different audio sources connected to the SRC‑System™ are
prioritized as shown below, i.e. the higher priority source will always
override and interrupt the lower one.
For example, incoming mobile phone calls and GPS navigation instruc-
tions will interrupt ongoing Click-to-Link calls, while incoming Click-to-Link
calls will interrupt the audio from the built-in FM Radio etc.
Click-to-Link established calls and Intercom calls have the same priority:
If one is in use, the other is unable to interrupt. Therefore, a Click-to-Link
request cannot interrupt an Intercom call in progress, and vice-versa.
1. mobile Phone audio or GPS instructions (device
Higher Priority

specific)
2. Intercom / Click-to-Link (same priority level)
3. A2DP audio source
4. Fm Radio (built‑in)
5. Auxiliary Line‑In Port (for corded connection
Lower Priority
e.g. mP3 players).
36
QG SRC 207 - MAN00015 indd 36
IC (Intercom) Request tone: If you are on a Click-to-Link call and
Rider A or Rider B try to connect to you for an IC Call, you will hear an
IC Request Tone while the other party will hear a rejection beep.
If your Click-to-Link connection is dropped for any reason and other
Click-to-Link-enabled units are nearby, new Click-to-Link connections
may link up with users other than your initial connection.
General Functions
Category Desired result
Making Start a Click-to-Link call
Click-to-Link request*
calls
Cancel a Click-to-Link call
Receiving Accept a Click-to-Link call
Click-to-Link
calls
Reject a Click-to-Link call
During End a Click-to-Link call
Click-to-Link
calls
* The SRC‑System™ searches for another Click-to-Link enabled unit for up to
10 seconds, while beeping and flashing red.
NOTe: Click-to-Link connections will not replace or change your current Rider
A and Rider B intercom pairings. Click-to-Link uses a separate temporary
channel to connect to a Click-to-Link conversation partner.
Required Action
Double tap Channel "A" Button
Tap Channel "A" Button
When you hear the ringtone,
tap Channel "A" Button or speak
loudly to answer by VOX
When hearing the ring tone,
remain silent for 10 seconds or
until the ring tone subsides
Tap Channel "A" Button
2/1/11 11 38 AM