Support; Important; Notices - SCHUBERTH SRC‑System Guía De Usuario

11. SUPPORT

For additional information please visit our website at
www.schuberth.com
For technical support please contact us at:
Kundenservice@schuberth.com
Phone: +49‑391‑8106‑555
For the latest information on Software upgrades please visit our
website at www.schuberth.com/en/products/service/
src‑systemtm.html and register on-line.
OPENING ACOUSTIC COLLAR ZIPPER VOIDS WARRANTY!
The electronic components inside the Acoustic Collar of the
SRC‑System™ are closed by a sealed zipper. Please do not tamper
with or open the zipper as this will void your warranty.
QG SRC 207 - MAN00015 indd 37

IMPORTANT:

12. NOTICES

Federal Communications Commission (FCC) / Industry Canada (IC)
Statement
15.21
You are cautioned that changes or modifications not expressly approved by
the part responsible for compliance could void the user's authority to oper-
ate the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC / IC rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Operation is subject to the following two conditions:
1) this device may not cause interference and
2) this device must accept any interference, including interference that may
cause undesired operation of the device.
37
2/1/11 11 38 AM