Bresser MyTime Travel Instrucciones De Uso página 19

2. The main unit should not stand close to metal
window frames.
3. Please do not using other electrical products, such
as headphones or speakers, operating on the same
signal frequency (433.92 MHz).
4. Electrical devices operating on the same signal
frequency may also cause interference. This can
include devices used in the neighborhood as well.
Main unit channel setting
1. The main unit can be connected with a maximum of
up to 3 transmitters.
2. Press the CHANNEL button to switch between the
displays of each channel. The main unit will display
the information of the corresponding transmitter.
Automatic time setting
1. After the batteries are installed. The clock will
automatically search for the radio signal. It takes
about 3-5 minutes to finish this process.
2. If the radio signal is received, the date and time will
be set automatically and the radio control signal
icon turns on.
If the clock fails to receive the time signal, go ahead
with the following steps:
All manuals and user guides at all-guides.com
1. Press and hold the UP button for 2 seconds to re-
2. If the time signal receiving fails again, the time can
Manual time setting
1. Press and hold the SET button in normal display
2. The figure to be set will start flashing.
3. Press DOWN or UP to change the value.
4. Press SET button to confirm and go to the next
5. The setting order is year >> month >> date
6. If there is no operation for 30 seconds, the existing
Alarm setting
1. Press and hold the ALARM button in normal display
initialize RC signal receiving.
be set manually.
mode for 2 seconds to enter into time setting mode.
value to be changed.
>> language selection for display of the day
(abbreivaited) >> time zone >> 12/24hr >> hour >>
minute >> save and exit.
setting will be saved and the device returns to
normal display mode. Press SET button again to
confirm and exit setting.
mode for 2 seconds to enter into alarm time setting
mode.
DE
GB
FR
IT
ES
19