Bresser MyTime Travel Instrucciones De Uso página 20

2. The figure to be set will start flashing.
3. Press the DOWN or UP button to change this
setting.
4. Press the ALARM button to confirm and go to the
next setting.
5. The setting order is hour >> minute >> save and exit.
6. Press ALARM again to confirm and exit setting
mode.
7. Press SET button to turn on or off the alarm, When
the alarm is activated, the icon
screen. When this alarm bell symbol is not displayed
the alarm is off.
8. The alarm sounds for a total of 2 minutes and will
change characteristics along that time.
Snooze/light function
1. When alarm is ringing, you can press the SNOOZE/
LIGHT button to silence it for 5 minutes. The icon
will now flash as well.
2. Press any other button to turn off the alarm. The
alarm will activate again after 24 hours at the set
time.
3. During normal operation mode, a press of the
SNOOZE/LIGHT button turns on the backlight for
20 seconds.
20
All manuals and user guides at all-guides.com
Temperature buzzer setting
1. Press and hold the DOWN button in normal display
Note: Make sure that you have set the correct channel
for the desired sensor.
2. Press the DOWN or UP button to turn on or off the
is showed on the
3. Press the SET button to confirm and go to next
4. The setting order is: temperature buzzer ON/OFF
Note: The range for maximum upper limit is 70°C and
maximum limit for lower temperatures is -50°C.
5. Press SET button again to confirm and exit setting.
Note: As long as the outside temperature has
exceeded or fallen below the set limits, the alarm
will sound every minute for a duration of 2 seconds.
Furthermore the display for the outdoor temperature
and the symbols
mode for 2 seconds to enter into temperature
buzzer setting.
temperature buzzer.
setting.
>> highest temperature limit >> lowest temperature
limit. If the UP or DOWN button is held and presses
continuously, the value will change faster.
or are flashing.