Cembre B-FC470 Manual De Uso Y Mantenimiento página 7

Do not use the tool for purposes other than those intended by Cembre.
The operator should concentrate on the work being performed and be careful to maintain a bal-
anced working position.
Before each use check the punches and dies, replace any that are worn or damaged, particularly
any punches that have damaged cutting surfaces.
Damaged or improperly assembled accessories can break and hit the operator with suffi cient
force to cause serious injuries.
Before each use, verify the integrity of the tool; replace any worn, possibly damaged or missing
parts with original Cembre spares.
The use of Cembre punching accessories is recommended. Accessories from other suppliers may
not be designed to withstand the force generated by this tool and may be damaged or break with
potential risk of serious injury.
Protect the tool from rain and moisture. Water will damage the tool and battery.
Electro-hydraulic tools should not be operated in pouring rain.
2. INSTRUCTIONS FOR USE
The part reference includes the following:
– Hydraulic hole punching tool.
– Li-Ion rechargeable battery (2 pcs).
– Battery charger (model depends on the tool version).
– Shoulder strap.
– Carrying case VAL-FC470.
– Canvas bag CVB-013.
– Stud type "B" .
– Stud type "C" (already mounted)
– Stud type "AB" (for previous series punches with 3/8 "-24UNF thread)
– Locking screws type "B" and "C" (2 pcs/type).
– 4 mm Allen key with handle.
– 3 mm Allen key for extractors.
– USB cable (Ref. to § 4).
2.1) Preparation
The tool can be easily carried using either the handle or the
shoulder strap attached to ring (9) (Ref. to Fig. 6).
Before starting any work, check the battery charge
(Ref. to § 2.7) and recharge if necessary, following the
instructions in the battery charger user manual.
To
replace the battery, remove it by pressing the release button (8), then insert the new battery,
sliding it into the guides until it locks.
7
WARNING
8
Battery