Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
Important! The fitting must be installed,
flushed and tested after the valid norms.
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin.
3. Slide the fixation piece including the washer
over the threaded pins and tighten the nuts.
4. Connect the supply pipes to the isolation
valves;
cold right - hot left.
5. Connect the pull rod to the pop-up waste.
The hot and cold supplies must be of equal pres-
sures.
Operation
The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
Technical Data
This mixer series-produced with water-
dimmer
(flow limiter)
®
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
6
English
Hansgrohe single lever mixers can be used to-
gether with hydraulically and thermically control-
led continuous flow heaters if the flow pressure is
at least 1.5 bars.
If the continuous water heater causes any problems
or there is not enough flow of water, the water-
dimmer
removed.
To adjust the hot water limiter on single lever mix-
ers, please see page 13.
No adjustment is necessary when using a continu-
ous flow water heater.
Spare parts (see page 3)
1
1.1 screw cover
2
3
4
5
6
7
8
9
7 l/min 3 bars
10 fixing set
14 l/min 3 bars
11 connection hose
max. 10 bars
1 - 5 bars
Special accessories
16 bars
X
max. 80° C
65° C
(8a) located behind the aerator must be
®
handle
flange
nut
service set
packing kit
mixer ball
cartridge cpl.
aerator cpl. (10)
pull rod
special tool set
(not part of delivery)
31091000
94186000
94130000
94106000
13952000
13962000
13964000
14095000
13085000
92620000
94138000
94076000
58085000
Publicidad
