Siemens Z 6.0 Instrucciones De Uso página 17

en
Changing the bag
Replacing the bag
19
Figure
If the bag change indicator is permanently lit when
the floor tool is lifted from the floor and the highest
suction setting is selected, the filter bag must be
replaced even if it is still not full. In this case it is
essential to change the bag due to the type of dust
which has been vacuumed.
First check that the nozzle, suction pipe and flexible
hose are not blocked, as this would also lead to the
bag change indicator being triggered.
20
Figure
When the opening button is pressed, the appliance
lid is raised slightly.
Reach underneath the lid and open in the direction
of the arrow until the lid engages in the open
position.
21
Figure
a)Seal the filter bag by pulling the locking tab and then
remove it.
b)Insert a new filter bag into the holder and close the
bag compartment lid.
!
Caution: the lid will only close when the filter bag
is inserted.
Cleaning the motor protection filter
The motor protection filter should be cleaned regularly
by knocking out the dirt and rinsing.
22
Figure
Open the bag compartment lid (see Figure 20).
Release the motor protection filter from the catch
and remove in the direction of the arrow.
Clean the motor protection filter by tapping it.
If it is very dirty, the motor protection filter should
be rinsed out.
The filter must then be left to dry for at least
24 hours.
After cleaning, insert the motor protection filter into
the appliance and close the bag compartment lid.
12
All manuals and user guides at all-guides.com
Replacing the micro-hygiene filter
Figure
Replacing the HEPA filter
Figure
If you have used the vacuum cleaner for fine dust
particles, clean the motor protection filter by knocking
out the dirt and, if necessary, replace the micro-
hygiene filter, activated carbon filter or HEPA filter.
Care
Always switch off the vacuum cleaner and pull out the
mains plug before cleaning the vacuum cleaner.
The vacuum cleaner and plastic accessories can be
cleaned with a commercial plastic cleaner.
!
The dust compartment can, if necessary, be cleaned with
a second vacuum cleaner or simply wiped with a dry cloth
or dusting brush.
Subject to technical modifications.
23*
Open the bag compartment lid (see Figure 20).
Release the filter holder by pressing the locking tab
in the direction of the arrow
Remove the foam filter and micro-hygiene filter.
Insert the new micro-hygiene filter and foam filter
into the filter holder.
Insert the filter holder into the vacuum cleaner and
clip into place.
24*
Open the bag compartment lid (see Figure 20).
Release the HEPA filter by pressing the locking tab in
the direction of the arrow and remove it from the
appliance.
Insert the new HEPA filter and clip into place.
Do not use a scourer, glass-cleaning agent or
all-purpose cleaning product.
Never immerse the vacuum cleaner in water.