Tabla de contenido
Publicidad
Figure 5
Fiber optic lasers, when they are installed,
comply with DHHS Rules 21 CFR Subchapter J,
Preventing EMI
When you run wires for any significant distance in an electromagnetic field, electromagnetic interference
(EMI) can occur between the field and the signals on the wires.
Note that:
•
•
To predict and remedy strong EMI, consult RFI experts.
Covering Empty Slots
Ensure that all cards, faceplates, and covers are in place. Blank faceplates and cover panels are used to:
•
•
•
Disposing of the System
Dispose of the system and its components (including batteries) as specified by all national laws and
regulations.
Regulatory Compliance and Safety Information for the Cisco 7500 Series Routers
36
Class 1 Laser Label for a Chassis
CLASS 1 LASER PRODUCT
LASERPRODUKT DER KLASSE 1
PRODUIT LASER DE CLASSE 1
PRODUCTO LASER CLASE 1
applicable at date of manufacture.
Manufactured:
APPARATEN SKALL ANSLUTAS
TILL JORDET NÄTUTTAG.
Bad plant wiring can result in radio frequency interference (RFI).
Strong EMI, especially when it is caused by lightning or radio transmitters, can destroy the signal
drivers and receivers in the system, and can even create an electrical hazard by conducting power
surges through lines and into the system.
Prevent exposure to hazardous voltages and currents inside the chassis
Help contain electromagnetic interference (EMI) that might disrupt other equipment
Direct the flow of cooling air through the chassis
B1
78-4194-10
Publicidad
Tabla de contenido
