Publicidad
The Cisco 7505, Cisco 7505-MX, Cisco 7507, Cisco 7507-MX, Cisco 7513, Cisco 7513-MX, and
Cisco 7576 meets the industry EMC, safety, and environmental standards described in
Table 2
Description
GR-63-Core NEBS Level 3
GR-1089-Core NEBS Level 3
ETS 300 019 Storage Class 1.1
ETS 300 019 Transportation Class 2.3
ETS 300 019 Stationary Use Class 3.1
GR-1089-Core Intrabuilding Lightning-Immunity Requirements
Caution
To comply with GR-1089-Core intrabuilding lightning-immunity requirements, you must use grounded,
foil twisted-pair (FTP), Category 5 cabling.
EMC Environmental Conditions for Products Installed in the
European Union
This section applies to products to be installed in the European Union.
The equipment is intended to operate under the following environmental conditions with respect to
EMC:
•
•
•
In addition, if equipment is operated in a domestic environment, interference may occur.
EMC Class A Statements/Warnings
This section includes the EMC Class A warnings for the Cisco 7505, Cisco 7505-MX, Cisco 7507, Cisco
7507-MX, Cisco 7513, Cisco 7513-MX, and Cisco 7576.
FCC Class A
Modifying the equipment without Cisco's authorization may result in the equipment no longer
complying with FCC requirements for Class A or Class B digital devices. In that event, your right to use
the equipment may be limited by FCC regulations, and you may be required to correct any interference
to radio or television communications at your own expense.
Regulatory Compliance and Safety Information for the Cisco 7500 Series Routers
24
Industry EMC, Safety and Environmental Standards
A separate defined location under user control.
Earthing and bonding shall meet the requirements of ETS 300 253 or CCITT K27.
Where applicable, AC power distribution shall be one of the following types:
TN-S
–
TN-C (as defined in IEC 364-3)
–
Table
2.
78-4194-10
Publicidad
