Publicidad
STEP 3
Brackets are currently set for
right hand hinge location. If
your hinges are on the left
side of your cabinet, you must
remove the brackets from all
(4) uprights and re-attach to
match their respective left
hand hinge diagram in Fig. 3.1.
Once you have the correct
hinge location for each upright,
insert (2) machine screws into
each L-bracket (See Fig 3.2).
NOTE:
Keep the machine screws
holding the L-brackets to the
upright loose until Step 12.
#2
#2
STEP 4
Attach the buttons to the
slides and install the uprights
into the cabinets as shown on
the provided template then
proceed to Step 11.
If you: purchased single
drawers with uprights, are not
using Blum slides, do not have
a template, or are using 5 mm
system holes located 4.88"
(124 mm) from the inside of
the face frame, then proceed
to Step 5.
If you are using cabinet system
holes that are not 4.88" (124
mm) from the inside of the face
frame, then skip to Step 9.
FIG.
3.1
UPRIGHTS FOR HINGE RIGHT SIDE CABINET
REAR UPRIGHTS
STANDARD POSITION
FRONT UPRIGHTS
UPRIGHTS FOR HINGE LEFT SIDE CABINET
REAR UPRIGHTS
(LEFT HAND HINGE)
XL POSITION
FRONT UPRIGHTS
INSTALLATION INSTRUCTIONS: PILASTER UPRIGHT KIT
(RIGHT HAND HINGE)
XL POSITION
STANDARD POSITION
FIG.
3.2
ENSURE ALL SCREWS
REMAIN LOOSE
UNTIL FINAL STEP
3
Publicidad
