Publicidad
STEP 5
NOTE: You must complete this
step if you purchased single
drawer sets with separate
uprights, are using your own
slides, do not have a template,
or are using 5 mm system
holes located 4.88" (124 mm)
from the inside of the face
frame.
First, attach one slide button
into a hole in the slide that is at
least 2-5/8" (66.7 mm) from the
front of the slide and attach
another button into a hole that
is at the rear of the slide (See
Fig 5). Repeat this for each
slide.
Once you have your buttons
placed, measure the distance
from the front of the slide to
the center of your first button
and record as A (See Fig 5).
NOTE: This measurement must
be at least 2-5/8" (66.7 mm).
Then measure the distance
from the center of your first
button to the center of the
second button and record as B
(See Fig 5).
A)
B)
NOTE: Your slide may not
appear as shown if you are not
using Blum slides.
4
FIG.
5
Customer Service: 800-626-1126 | rev-a-shelf.com
B
SLIDE BUTTON POSITIONS
YOUR SLIDE MAY NOT APPEAR AS SHOWN
SECURE BUTTONS WITH
PROVIDED SCREWS AS SHOWN
A
2-5/8"
(66 mm)
Minimum
Publicidad
