Publicidad
STEP 8
Locate the correct rear upright
(See Fig 8). Align front edge
of uprights to the mark made
in Step 7 and attach uprights
while keeping them in contact
with bottom of cabinet and
brackets facing rear of cabinet.
NOTE: Confirm your upright
is straight and plumb with
the cabinet floor before
attachment. Attach to cabinet
using (4) #8 x 3/4" deep thread
screws per upright. Repeat for
the opposite upright and skip
to Step 10.
STEP 9
If you are using 5 mm system
holes located 37 mm and 406
mm from the inside of the face
frame then use euro screws
(not provided) to attach all
uprights to wall (See Fig 9.1).
NOTE: Confirm your upright
is flush and plumb with the
cabinet floor before inserting
euro screws through the slots
labeled "B" on the L-bracket.
Attach a slide button into a
hole in your slide that is at least
2-3/4" (70 mm) from the front
of the slide and attach another
button that is 15-3/16" (386 mm)
torwards the rear of the slide
(See Fig 9.2). Repeat this for
each slide.
NOTE: Your slide may not
appear as shown if you are not
using Blum slides.
6
FIG.
8
LEFT HAND REAR
FIG.
SIDE VIEW OF CABINET
9.1
1-1/4"
(44 mm)
FIG.
9.2
Customer Service: 800-626-1126 | rev-a-shelf.com
1-29/64"
(37 mm)
16"
(406 mm)
15-3/16"
(387 mm)
RIGHT HAND REAR
2-3/4"
(70 mm)
Publicidad
