Best WC45 Serie Manual Del Usuario página 5

OPERATION
Controls (Fig.1)
Button TC1 (Lights)
Switches main light ON/OFF
Button TC2 (Motor-V1)
Motor ON/OFF - Activates the motor at 1st speed.
Button TC3 (Motor-V2)
Activates the motor at 2nd speed.
Button TC4 (Motor-V3)
Activates the motor at 3rd speed.
Button TC5 (Motor-V4)
Activates the motor at 4th speed.
Button TC6 (TIMER auto power off 10 min.)
Activates the TIMER function at the speed that has already been selected If the motor is NOT active, it
switches on the motor at the 1st speed and activates the TIMER function When the TIMER function is
active, BL6 lighting blinking.
- Press key TC2 and TC5 simultaneously for 5 seconds; when the function is activated all the LEDs
switch off, then keys TC2, 3, 4 , 5 activate fl ashing three times; then TC2 key and the selected
speed switch on.
- In order to store the new setting, press shortly key TC2 or wait 15 seconds. Your setup is memori-
zed.
- When the new setting is memorized, key TC2 fl ashes twice and then all the LEDs switch off.
Cleaning Mode
Pressing simultaneously for 2 seconds keys TC1 and TC6 activates the glass cleaning function. When
the function is active the system does not recognize any key. When the cleaning Mode is active TC1
and TC6 backlight is steadily on. The function will stay on for maximum 5 minutes. To stop the Clea-
ning Mode press for 2 seconds keys TC1 and TC6 simultaneously or wait for 5 minutes.
30h fi lter ALARM
After 30 hours of operation, an alarm switches on to signal the need for anti-grease fi lter cleaning.
The fi lter alarm, when active, is displayed for 30 sec each time the motor is deactivated: BL6 lighting
ON. During this period, it is possible to reset the alarm by pressing the TC6 button for longer than a
second.
120h fi lter ALARM
After 120 hours of operation, an alarm switches on to signal the need for active carbon fi lter (optional)
replacement. The fi lter alarm, when active, is displayed for 30 sec each time the motor is deactivated:
BL6 lighting blinking. During this period, it is possible to reset the alarm by pressing the TC6 button for
longer than a second.
Buzzer
The Buzzer emits a "beep" each time that a command is set from the keyboard or remote control
(optional).
HEAT SENTRY™
Your hood is equipped with a HEAT SENTRY™ thermostat. This thermostat is a device that will turn
on or speed up the blower if it senses excessive heat above the cooking surface.
1) If blower is OFF - it turns blower ON to HIGH speed.
2) If blower is ON at a lower speed setting - it turns blower up to HIGH speed.
When the temperature level drops to normal, the blower will return to its original setting.
WARNING
The HEAT SENTRY thermostat can start the blower even if the hood is turned OFF. When this
occurs, it is impossible to turn the blower OFF with its switch. If you must stop the blower,
do it from the main electrical panel.
WARNING
The unit is equipped with infrared sensor controls that, if exposed to direct sunlight may not work
properly; use curtains or other devices to shield the sunlight.
BL1 BL2 BL3
TC1 TC2 TC3
BL4 BL5
TC4 TC5
- 6 -
BL6
TC6