Toto CST412MF Instrucciones Para La Instalación página 3

6
Securing Bowl to the mounting blocks
Install the side screws to the mounting blocks.
Cover the screw head with the provided
screw-cap.
IF THE SIDE SCREW DOES NOT
HIT THE MOUNTING BLOCKS,
THEN TOILET BOWL IS NOT
FULLY INSERTED IN THE SOCKET.
If toilet is not installed properly, it may slide
out of socket or leak.
Please ensure that both sides are properly
fitted and secure. Be sure not to over-tighten
CAUTION
the screws, as it may results in product damage.
7
Connect Water Supply to the fill valve
Water supply must be connected to the fill
valve BEFORE tank to bowl installation.
• TOTO RECOMMENDS USING A FLEXIBLE
SUPPLY HOSE
• CAUTION! DO NOT OVER-TIGHTEN THE
COUPLING NUT. 1/4 TURN MAX AFTER
HAND TIGHTENING
Please be sure to connect water supply to fill valve
before installing tank to bowl. If procedure is re-
versed, water supply installation may be impossible.
FAILURE TO FOLLOW THIS INSTRUCTION MAY
CAUTION
RESULT IN PERSONAL INJURY AND/OR PROPERTY
DAMAGE.
8
Installing Tank to the Bowl
CONNECT WATER SUPPLY TO FILL VALVE BEFORE
INSTALLING TANK TO BOWL.
WHEN INSTALLING TANK TO BOWL, ENSURE THAT
CAUTION
TANK IS NOT TOUCHING THE BACK WALL.
• REMOVE WARNING STICKER FROM
BOWL
• Make sure fill valve nut and flush valve
nut are tightened properly. Install tank
to bowl gasket over flush valve outlet on
underside of the tank.
• Pick up the tank and carefully guide the
flush valve outlet into the bowl inlet on
the bowl tank-shelf. Make sure the bolts
on the bowl, fit through the opening in
the base of the tank.
9
Installing Tank to the Bowl
1. Remove the top-portion of the flush valve for easy assembly by
disconnecting the refill tube, turning the upper portion of the valve
counter-clockwise, and pulling up.
2. Insert the rubber washer then metal washer on the mounting bolt.
Thread on nuts, hand tighten before releasing the tank. Tighten
nuts evenly until tank sets snugly on the bowl.
3. Re-install flush valve and refill tube.
CAUTION
10
Water Connection
1. Connect opposite end of the water supply tube to angle
stop.
2. Open supply valve and flush toilet several times.
3. Carefully check all connections for leaks.
4. Periodically check for leaks several days following the
installation.
11
Lid Installation
1. Carefully place lid on top of tank making sure
that the push rod colors match the flush valve
buttons (blue to blue and white to white).
For replacement or readjustment of push rod height
2. Push down on one button, while pulling the opposite
button up with your finger to remove.
3. Use the provided longer push rod, and insert them
thru push button housing.
4. Cut the push rod at the shown location.
5. Install the rods into the push buttons, and insert the
buttons in the housing until they click into place.
6. When inserting the buttons, make sure that the rod
colors match with the flush valve button colors (blue to
blue and white to white).
12
Seat Installation
1. Toilet seat is installed with top-mount bolt
Gasket
set.
2. Insert the rubber bushing-nut into the
seatmounting holes.
3. Place seat on bowl and rotate the hinge
unit into place while holding seat down on
bowl.
4. Tighten the bolt from top with screwdriver.
Do not over-tighten the mounting bolt. Over
tightening may result in product breakage and
cause personal injury and/or property damage.
Water supply pressure should
be between 20psi & 80psi static.
Seat Bolt
Left Right
Half flush Full flush
Cut this portion
Rubber Bushing
Net
3