Chapter 5 - Use; Acquisition Of Radiographic Images - KaVo DEXIS Titanium 1.014.6083 Manual Del Usuario

Chapter
5

Acquisition of Radiographic Images

Turn on the PC that has the DEXIS Titanium installed and launch the imaging
software, such as VixWin Platinum (please refer to the software manual for
information on the software program).
1. Carefully plug the USB end of the sensor cable into the PC USB port.
Do not use force, ensure that the plug is properly oriented with the PC
port. Try rotating the USB plug if it does not easily insert into port.
CAUTION
Use extreme care when mounting the sensor inside a cabinet.
Pinching/crushing the sensor cord or USB Extension Cable can
damage the cord and cause image derogation or failure.
2. Set the required technical settings (exposure time, etc.) on the X-ray
generator (refer to X-ray Dose / Exposure Time Settings on page 5-4.
CAUTION
Use DEXIS Titanium Holders and Positioning System only.
3. Assemble the rings, bars and holders so that the entire sensor area is
visible through the ring. This applies to horizontal or vertical Bitewing
holders, and Periapical (anterior or posterior) holders.
4. Apply a new disposable sheath to the image sensor, making sure that
it covers the portion of the cable which may come into contact with the
patient.
CAUTION
When twisting the disposable covers around the sensor wire, be sure
not to twist the wire.
English
Use
5-1