Functional Description; Initial Commissioning; Base Plate 1 688 - Bosch SCT 815 Manual Original

1 m
4712008-12_shd
(1) Area where SCT 815 is set up
(2) SCT 815 resting surface (example)
---
Calibration environment
Metallic objects interfere with front radar sensor
calibration.
• The area between the vehicle and SCT 815 must not
contain metallic any objects.
• The area within a radius of 2 m around SCT 815 must
not contain any metallic objects.
4712008-12_shd
1
(1) Manufacturer-specific area between the vehicle and SCT 815
(see brief instructions)
(2) Area around SCT 815
(3) SCT 815
---
Diagnostic software
• Diagnostic software for calibrating the front radar
sensor
• If [ESI]tronic 2.0 is used as diagnostic software: info
type SD (control unit diagnosis) and KTS
---
2.5 Laser range finder GLM 120 C
Only GLM 120 C may be used as a range finder
for aligning SCT 815.
The laser range finder GLM 120 C is used to position
SCT 815 in front of the vehicle and to adjust the height
of the prismatic reflector.
The following properties of the laser range finder
GLM 120 C ensure that SCT 815 can be positioned pre‐
cisely as specified in the brief instructions specific to
the vehicle:
• Continuous distance measurement
• Display of inclination angle
• Rear edge as reference point for distance measure‐
ment
---
Robert Bosch GmbH
5 m
1 2
3
2
2.6

Functional description

A prismatic reflector must be used to calibrate the front
radar sensor of the makes Mazda, Honda, Toyota, Kia
and Hyundai. For the front radar sensor to be calibra‐
ted, the prismatic reflector must be positioned in front
of the vehicle at a distance and height specific to that
vehicle. The adjustment device SCT 815 is used to put
the prismatic reflector in that vehicle-specific position.
As soon as the prismatic reflector is in its vehicle-spe‐
cific position, the calibration must be started using di‐
agnostic software. The front radar sensor emits signals
focused and reflected back to the front radar sensor by
the prismatic reflector. The calibration will be success‐
ful if the prismatic reflector is precisely aligned. The
calibration may fail if the prismatic reflector is not pre‐
cisely aligned or the measurement bay requirements
are not met.
---Separator---
3.

Initial commissioning

---Separator---
3.1 SCT 815 installation
1. Make sure all components specified in the scope of
delivery are present.
2. Position the guide tubes with the tube connectors
(1)
over the holes in the base plate.
4 Nm
1 1
3
4
2
(1) Guide tube with tube connectors
(2) Base plate
(3) Hex socket head cap screw
(4) Washer
3. Use the hex socket head cap screws
(4)
to secure the tube connectors on the base plate
at 4 Nm.
4. Slide the preassembled tool holder
guide tubes, and use the knurled screw
it.
SCT 815 | 15 | en
(3)
and washers
(1)
onto the
(2)
to secure
1 689 989 475 | 2020-05-01