Bosch SCT 815 Manual Original página 19

1 1
2 2
(1) Line laser
(2) Spirit level on line laser mount
(3) Positioning feet
(4) Retaining cable
 WARNING – severe eye damage from laser beam.
3. Never look directly into the laser source.
4. To test function, hold an object in front of the line
laser exit point.
5. Switch on the line laser.
 The laser line now runs across the vehicle.
6. Align SCT 815 in such a way that the laser line
runs across the manufacturer badge on the front of
the vehicle and the antenna.
1
3
2
(1) Line laser
(2) Projected laser line
(3) Manufacturer badge
(4) Antenna
Depending on the vehicle, other fixed points can
be used to align SCT 815 with the vehicle's longi‐
tudinal center plane using the line laser.
---Separator---
4.5 Adjusting the height of the prismatic
reflector
4.5.1 ---Separator--- Adjusting the height of the prismatic reflector
according to the millimeter
The height of the prismatic reflector is specified in the
corresponding brief instructions. The height specific to
Robert Bosch GmbH
4
3 3
(2)
4
the vehicle is found in the column with the following
pictogram.
The vehicle-specific height from the brief instruc‐
tions applies if the vehicle rests on the same sur‐
face as SCT 815. If the vehicle rests on a lift or
leveling surface, the difference in height must be
measured. The measured height must be added
to the vehicle-specific height from the brief in‐
structions.
1. Use the corresponding brief instructions.
2. Look up the height of the prismatic reflector for the
relevant vehicle.
3. Position the mount for the laser range finder
the prismatic reflector (2).
1
2
(1) Mount for laser range finder
(2) Prismatic reflector
4. Make sure the edges of the prismatic reflector
are aligned with the centers of the notches
mount for the laser range finder.
1
2
(1) Edges of prismatic reflector
(2) Notches in mount for laser range finder
SCT 815 | 19 | en
(1)
on
1
(1)
(2)
in the
1
2
4712008-10_shd
1 689 989 475 | 2020-05-01