Settings - Festool CARVEX PSC 400 EB Manual De Instrucciones

Charger wall mounting TRC 3
There are two elongated holes on the back of the
TRC 3 for mounting the charger to a wall using two
screws (e.g. round head or flat head screw with
shank diameter of 5 mm).
X
Insert the two screws into the wall at a distance
of 96 mm from one another and leave the screw
heads protruding approx. 4 mm.
Consider the pictures on the fold-out page.
WARNING
Risk of injury, electric shock
X
Always disconnect the battery pack before any
type of work on the machine!
Stroke speed control
The number of strokes can be adjusted steplessly
with the adjusting wheel [1-5] between 1500 and
3800 rpm (PSBC 400 EB: 1000 - 3800 rpm). This en-
ables you to optimise the cutting speed to suit the
respective material.
In position A, the automatic load detection is acti-
vated: The stroke speed is reduced in idling and is
controlled to the highest value when the blade en-
ters the workpiece.
Recommended stroke speed (position of the
adjusting wheel)
Hard and soft wood, plywood board, ply-
wood, chip board
Hardboard
Plastic
Ceramic, aluminium, non-ferrous metals
Steel
Adjusting the pendulum stroke
In order to process different materials with an opti-
mum feed movement the pendulum jigsaws have
an adjustable pendulum stroke. Select the desired
setting with the pendulum stroke switch [1-11]:
setting 0 = pendulum stroke off
setting 3 = maximum pendulum stroke
Recommended settings of the pendulum stroke
Hard and soft wood,chip board, wood fibre
board
All manuals and user guides at all-guides.com

Settings

A
4 - A
3 - A
3 - 5
2 - 4
1 - 3
4 mm
0.16''
96 mm
3.78''
Recommended settings of the pendulum stroke
Wood core plywood, plywood, plastics
Ceramic
Aluminium, NF metals
Steel
Using the chip guard
The chip guard [1-1] prevents chips flying away and
improves the efficiency of the chip extraction sys-
tem.
X
Using minimal pressure, push the chip guard
[1-1] downwards.
Changing saw table
X
Open the change lever [1-8].
X
Removing the saw table downwards.
L Assembly is performed in reverse sequence to
removal. Ensure that the saw table is firmly
seated in the guide.
Instead of the saw table, the angle table WT-PS 400
or adaptation table ADT-PS 400 can be installed at
the support.
Never saw without the saw table, or one of
the other tables offered in the Festool acces-
sories program.
Inserting splinterguard
The splinterguard makes cuts with splinter-free
cutting edges possible, even on the exit side of the
saw blade.
X
With the machine switched off, push the splin-
terguard [4-1] onto the guide up to the saw
blade [4-2],
X
switch on the jigsaw,
X
with the machine running (stoke speed position
5), push the splinterguard in on a flat plane until
it is flush with the front edge of the saw table.
This beds in the splinterguard.
1 - 2
0
0 - 2
0 - 1
11