Settings - Festool CSC SYS 50 EBI Manual De Instrucciones

Further information about the charger and
battery pack with capacity indicator can be
found in the corresponding operating
manual.
9

Settings

For additional information, see
www.festool.com/QuickGuide-CSCSYS
9.1 Settings on the control module
Ensure that the area around the saw blade is
free when you are applying settings to the saw
blade.
The following settings can be set and adjusted
using the control module:
– Lang
– Unit
– Speed
– Cutting height (saw blade height)
– Calibrating the cutting height
– Cutting angle (saw blade angle)
– Calibrating the cutting angle
– Selecting and assigning favourites
– Ref. movement
– Resetting to factory settings
An assistant is available in the menu to help
with the following settings:
– Reference movement
– Initial steps
– Calibrating the cutting height
– Calibrating the cutting angle
– Changing the saw blade
Navigating
Navigate through a menu, an assistant or a
range of selection options
► Turn the dial [2-4] to the left or right.
Open the main menu.
► Press the dial twice.
Selecting
Start an assistant or confirm a selection
► Press the dial.
9.2 Festool Work App*
The power tool can be configured with the
Festool Work app. At least one of the two bat­
tery packs used must be a Bluetooth
pack
The battery pack is connected via
Bluetooth , see the operating manual for
®
the battery pack.
You can find further information about op­
erating the power tool in the
Festool Work app.
* Not available in all countries.
9.3
The speed can be adjusted in six settings using
the control module, depending on the work­
piece requirements.
9.4
Adjust the cutting height using the control mod­
ule.
► Press the height button [2-2].
► Set the desired cutting height on the di­
al [2-4] within ten seconds.
To end setting mode early, before ten sec­
onds have passed: Press the height but­
ton.
Adjusting the cutting height in tenths:
Press the dial while turning it.
9.5
Upon initial commissioning and after changing
the saw blade diameter, the cutting height must
be calibrated. A saw blade diameter can be
changed by sharpening or replacing the saw
blade.
Start calibration via the "Calibrating cutting
height" menu item on the display. Follow the in­
structions on the display.
► Press the dial to lower the saw blade until
it's below the table.
► Place a short waste strip on the sliding ta­
ble on the preset profile setting rail (as for a
cross cut).
► Press the dial to confirm the step.
► Switch on the saw blade at the start
switch [2-5].
► Perform a cross cut. When doing so, slowly
turn the dial to move the saw blade slowly
and gradually upwards.
If the saw blade scratches the waste strip, the
zero point has been reached and the saw blade
can be switched off.
► Press the dial to save this setting as a new
zero position.
battery
®
Setting the speed
Setting the cutting height
Calibrating the cutting height
English
33