Working With The Machine; Switch On/Off - Festool CARVEX PSC 400 EB Manual De Instrucciones

Inserting saw blade
WARNING
Risk of injury, electric shock
X
Always disconnect the battery pack before any
type of work on the machine!
6
6-1
6-2
X
If necessary, push the chip guard [1-1] upwards.
CAUTION
Material with high dust generation (e.g. plaster-
board)
Damage to machine through dust penetration,
risk of injury
X
Do not work overhead!
WARNING
Risk of injury
X
With the tool switched off and unplugged, check
for tight fit of the sawblade before starting to
work
X
Always apply the pendulum jigsaw to the work-
piece with the sawblade running.
X
Wait until the power tool stops completely until
placing it down. The tool can become entangled
and lead to a loss of control of the power tool.
When working on small or thin workpieces, always
use a stable base.
All manuals and user guides at all-guides.com
6-3
6-4

Working with the machine

X
Push the saw blade [6-4] into the opening as far
as the stop with its teeth in cutting direction [6-
2].
X
Turn the saw blade [6-4] approx. 30° clockwise
until it engages.
The guidance jaws adjust automatically to the saw
blade used.
Check that the saw blade is secure. A loose
saw blade can fall out and cause an injury.
L In the case of very short saw blades, it is advis-
able to remove the saw table (see chapter
Changing saw table) before inserting the saw
blade.
Ejecting saw blade
L When ejecting the saw blade, hold the electric
power tool such that no persons or animals can
be injured.
X
Push the saw blade ejection [6-3] forwards as
far as the stop.
If the saw blade is not ejected: run jigsaw 3 - 10
seconds at a high speed. Actuate saw blade ejector
mechanism [6-3] once again.
When working, hold the electric power tool by the
handle and guide it along the desired cutting line.
For precise cuts and smooth running, use two
hands to guide the electric power tool.
Freely guided sawing along a scribe mark
The triangular shape of the splinterguard [4-1]
points to the cutting line of the saw blade. This fa-
cilitates sawing along a scribe mark.

Switch on/off

The electric power tool has one button [1-2] on
each side for switching on/off.
The PSBC 400 EB also has a variable speed trigger
[1-3] with switch lock [1-4]. For continuous opera-
tion, use the button [1-2].
Lighting
WARNING
The stroboscope light may make it difficult to de-
termine the saw blade position
Risk of injury
X
Ensure the work area is well illuminated.
13