Safety Instructions - DeWalt DCS387 Manual De Instrucciones

Ocultar thumbs Ver también para DCS387:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Alwaysuse NIOSH/OSHA approved respiratory protection
appropriate
forthedust
e xposure. Direct particles away from face
and body.
_WARNING:
Always wear proper personal hearing protection
that conforms to ANSI $12.6 ($3.19) during use. Under some
conditions
and duration of use, noise from this product
may
contribute to hearing loss.
_CAUTION:
When not in use, place tool on its side on a stable
surface where it will not cause a tripping or falling hazard.
Some tools with large battery packs will stand upright on the battery
pack but may be easily knocked over.
The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V................... volts
A ...................... amperes
Hz ................. hertz
W. .................... watts
min ............... minutes
---
or DC... direct current
(_) ................. Class I Construction
(grounded)
[] ................. Class II Construction
(double insulated)
.../min .......... per minute
BPM ............. beats per minute
IPM ............... impacts per minute
RPM ............. revolutions per
minute
sfpm ............. surface feet
per minute
SPM ............. strokes per minute
or AC .......... alternating
current
_-_or AC/DC...altemating
or direct
current
no .................... no load
speed
n ...................... rated
speed
..................... earthing
terminal
,_,..................... safety alert
symbol
Important
Safety
Instructions
for All
Battery
Packs
When ordering replacement battery packs, be sure to include the
catalog number and voltage. Consult the chart at the end of this
manual for compatibility of chargers and battery packs.
The battery pack is not fully charged out of the carton. Before using
the battery pack and charger, read the safety instructions below and
then follow charging procedures outlined.
READ
ALL INSTRUCTIONS
Do not
charge
or use the
battery
pack
in explosive
atmospheres, such as in the presence of flammable liquids,
gases or dusL Inserting or removing the battery pack from the
charger may ignite the dust or fumes.
NEVER force the battery
pack into the charger.
Do not
modify the battery pack
in any way to fit into a non-
compatible
charger as battery pack may rupture causing
serious personal
injury. Consult the chart at the end of this
manual for compatibility of batteries and chargers.
Charge the battery packs only in designated DEWALT chargers.
DO NOT splash or immerse in water or other liquids.
Do not store or use the tool and battery
pack in locations
where the temperature
may reach or exceed 105 °F (40 °C)
(such as outside sheds or metal buildings in summer). For
best life store battery packs in a cool, dry location.
NOTE: Do not store the battery
packs in a tool with the
trigger switch locked on. Never tape the trigger switch in the
ON position.
_ WARNING: Fire hazard. Never attempt
to open the battery
pack
for any reason.
If the battery
pack case is cracked or
damaged,
do not insert into the charger. Do not crush, drop or
damage the battery pack. Do not use a battery pack or charger that

Publicidad

Tabla de contenido
loading

Tabla de contenido