Stanley FatMax FMFP70979 Manual De Instrucciones página 20

Compresor de aire portatil electrico de 4 galones para contratistas
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CODE POSSIBLE CAUSE
9
Compressor is not large enough for acces-
sory
10
Hole in air hose
11
Check valve restricted
12
Air leaks
13
Regulator is damaged
14
Unit operating in damp or humid conditions
15
Restricted air intake filter
16
Pump oil is low
17
Carbon build-up in pump.
Detergent type oil being used in pump
18
Motor overload protection switch has tripped See Motor Overload under Features.
19
20
Extension cord is wrong length or gauge
Loose electrical connections
21
Possible defective motor or starting
22
capacitor
All manuals and user guides at all-guides.com
POSSIBLE SOLUTION
Check the accessory air requirement. If it is higher than the SCFM or pres-
sure supplied by your air compressor, a larger compressor is needed to
operate accessory.
Replace air hose.
Remove, clean or replace.
Tighten fittings.
Replace.
Move unit to a dry well ventilated area
Clean or replace air intake filter
Add air compressor oil (SAE 40) to pump. See Compressor Pump Oil under
Maintenance.
Contact a Stanley Tools factory service center or a Stanley Tools authorized
service center.
Drain oil and refill pump with air compressor oil (SAE 40).
Check for proper gauge wire and cord length. See Extension Cords under
Installation.
Contact a Stanley Tools factory service center or a Stanley Tools authorized
service center.
Contact a Stanley Tools factory service center or a Stanley Tools authorized
service center.
20

Publicidad

Tabla de contenido
loading

Tabla de contenido