Maintenance And Cleaning; Monitoring And Maintenance; Cleaning - Ivoclar Vivadent Stratos 100 Instrucciones De Uso

7. Maintenance and Cleaning

This chapter describes the user maintenance and cleaning procedure for the Stratos 100. Only those tasks that can be carried out by
qualified dental lab experts are listed. All other tasks must be performed by qualified service personnel at a certified Ivoclar Vivadent
Service Center.
7.1

Monitoring and maintenance

The time for these maintenance procedures depends on the frequency of use and the working habits of the user. For these reasons, the
recommended times are only approximates.
What
Check centric rubber band for damage and
cracks and replace, if necessary.
Check if knurled screws are dirty.
Check if joint bolt is sufficiently lubricated.
Check if incline support holder and holding
device are dirty.

7.2. Cleaning

What
Knurled screws contaminated with wax or
plaster
Joint bolt contaminated with dust
Protect the Stratos 100 from acids and
solvents (e.g. MMA) to prevent the
finish from being damaged.
Part
Centric rubber band
Knurled screw
Joint bolt
Holding device for incline support holder
Frequency
Weekly or as necessary
Weekly or as necessary
Frequency
Monthly or as necessary
Weekly
Monthly or as necessary
Weekly or as necessary
Cleaning agent/Measure
Rinse with warm water
Rinse with warm water
17