Adjusting The Tcp - Abicor Binzel CAT 3 Instructivo De Servicio

CAT 3

6.2 Adjusting the TCP

1
1 Hexagon nut M8
2 Dowel screw 6H7
Fig. 8 Adjusting the TCP
1 Loosen the hexagon nut (1) and adjust the torch mount (3) to the desired
TCP.
2 Tighten the hexagon nut (1).
To secure the adjusted position proceed as follows:
2
3 Torch mount
4 Hexagon nut M6
3 Drill a Ø 5.8 mm bore hole into the bracket (6) and use a reamer to ream
the bore for the dowel screw (2).
4 Use a dowel screw (2) and a hexagon nut (4) to secure both brackets (6)
and (3).
 4 Scope of delivery on page EN-11
6 Putting into operation
3 4
5 Dowel screw M8
6 Bracket
5
6
EN - 15