Connecting The Cable Assembly - Abicor Binzel PP Serie Manual De Instrucciones

PP
4.1.2 Liner (plastic)
1
10
9
8
1 Wire conduit
2 Central connector
3 Nut
4 Wire feeder
Fig. 3 Shortening the PA liner

4.2 Connecting the cable assembly

For use with aluminium, copper, nickel and stainless steels
40°
7
5 ABICOR BINZEL Cutter
6 O-ring
7 Clamp nipple
1 Lay down the cable assembly straight and unscrew nut from central
connector (2) .
2 Sharpen the beginning of the PA liner (8) to approx. 40° using the
ABICOR BINZEL sharpener.
3 Slide PA liner (8) through the wire conduit (1) into the inlet nipple (10) until
a noticeable resistance is felt.
4 Slide clamp nipple (7), O-ring (6) and nut (3) on the PA liner (8) and
tighten the nut (3) under tension.
5 Mark a PA liner (8) that is too long in front of the wire feed rolls (4) .
6 Cut the PA liner (8) at the mark directly in front of the wire feed rolls using
the ABICOR BINZEL cutter (5) .
7 Sharpen the cutting point.
1 Join central connector and central socket at the wire feed unit and secure
them with the connection nut.
2 Properly mount the connections for water supply/return, shielding gas and
control lead plug.
2
6
8
9 ABICOR BINZEL
10 Inlet nipple
4 Putting into operation
3
4
5
Liner (plastic)
Sharpener
EN - 7