Oven Care And Cleaning; Replacing The Oven Lamp - Haier H05RR-F Instrucciones De Uso

Oven care and cleaning

H2O CAVITY CLEAN
This function performs a cleaning cycle by
injecting steam into the cavity for 15 minutes.
At the end of the cycle, any crusting that may
have formed due to high-temperature cooking
inside the oven cavity, will be softened and
become much easier to remove.
H2O CIRCUIT CLEAN
This function performs a cleaning cycle of the
circuit, so as to maintain cleanliness and efficacy
over time.
WATER DISCHARGE
At the end of each steam cooking session - and
after all the cleaning processes - we recom-
mend discharging any residual water.

Replacing the oven lamp

IMPORTANT: The oven lamp must have the
following characteristics:
• Structure suitable for high temperatures
(up to 300 °C);
• Power supply: see the V/Hz value on the
serial number plate;
• Power 25 W;
• Type G9 connector.
ATTENTION: Make sure that the appliance is
turned off before replacing the lamp to prevent
electric shocks.
By pressing the On/Off button, before going to
stand-by mode, follow the instructions on the
screen to proceed with the water discharge.
1. Pull out the tank to the indicated mark
2. Wait for discharge
3. Empty the tank
• To avoid damage, spread a tea towel for pots
and pans inside the oven;
• Remove the screws holding the steel frame;
• Remove the old lamp by sliding it out of its
seat and taking care not to break it;
• Insert the new bulb, taking care not to touch
it with your hands (we recommend using
a disposable latex glove);
• Replace the stainless steel frame, taking care
not to pinch the silicone gasket seal;
• Re-insert the stainless steel screws you
previously removed;
• Connect the appliance to the power.
EN 37