Care And Cleaning; Troubleshooting - Oster FPSTJE317 Guia Del Usuario

CARE AND CLEANING

1. Unplug from outlet before disassembling and cleaning.
2. After disassembling all removable parts of the juice extractor, wash them
by hand with warm soapy water or in the dishwasher (top shelf only). If
the pulp dries out in the pulp collector container, the filter or the filter
basket, let it soak in water for approximately 10 min before washing it.
3. Wipe the motor base with a damp cloth.
4. It is very important to keep the filter very clean, free of residue blocking
the holes in order to ensure optimal performance. Wash it thoroughly
with warm soapy water. If the holes in the mesh remain blocked, soak the
filter in hot water with a water solution with 10% lemon juice.
CAUTION: DO NOT IMMERSE THE MOTOR BASE IN WATER OR ANY OTHER
LIQUID.
CAUTION: MAKE SURE THE PARTS ARE NOT DAMAGED BEFORE
ASSEMBLING THEM BACK TOGETHER.
WARNING: To reduce the risk of personal injury before and after juicing,
always visually examine the stainless steel filter for any damage or dents in
the metal surface. If present, replace the stainless steel filter and dispose of
any juice that was made.
EXCLUSIVE FILTER AUTO-CLEAN TECHNOLOGY
Your juice extractor includes a patented innovative filter auto-clean
technology that makes cleaning a fast and easy task.
1. Remove food pusher from food chute.
2. Twist open food pusher lid.
3. Fill water compartment inside food pusher to the "MAX" level .
4. Replace and turn lid clockwise to lock it into place on food pusher.
5. Place food pusher back on food chute ensuring the tab on the food pusher
aligns with the top of the mechanism for auto-clean.
6. Turn the control knob to the auto-clean position.
7. Press and hold down the food pusher. Auto-clean feature will
automatically shut off after 25 s.
8. Stop pressing down on food pusher.
9. Turn control knob to the off position.
10. Remove and empty out the jar and pulp collector container and wash them.
Your juice extractor is now clean and ready to be used again.
NOTE: Never use the Auto Clean mechanism during juicing or in dry
condition.
MAINTENANCE
Some plastic parts might stain when in contact with some fruits and
vegetables for too long. In order to avoid this from happening, all parts
should be washed immediately after each use.
This appliance has no user serviceable parts. Any servicing beyond that
described in the Cleaning Section should be performed by an Authorized
Service Representative only. See warranty section.
9 www.oster.com
FPSTJE317_FPSTJE318_20ESM1 (US).indd 9-10 FPSTJE317_FPSTJE318_20ESM1 (US).indd 9-10

TROUBLESHOOTING

Your Oster® appliance has been carefully designed to give you many years
of trouble free service. In the unlikely event that your new appliance does
not operate properly, please review the following potential problems and
try the steps recommended BEFORE you call or take it to an Authorized
Oster® Service Center.
PROBLEM
Juice Extractor will not • Stainless steel locking arm may not be locked
work properly in its position.
after switching on "I" or "II". • Turn off and unplug unit and ensure all parts are
assembled properly.
• Turn off and unplug unit and check if there is any
residue blocking the unit.
Motor makes loud noise • Turn off and unplug unit and ensure all parts are
and assembled properly.
unit starts vibrating. • Juicing overripe fruits may produce too much pulp
and clog the filter. Turn off and unplug unit and
clean the filter thoroughly.
Motor appears to stall • If pulp starts building up under the lid, slow down
when juicing. the juicing process. Turn off and unplug unit and
clean the filter basket, the stainless steel filter and
the lid.
Too much pulp build up. • Follow the instructions to disassemble the unit
included in the "After Using Your Juice Extractor"
section. Clean up pulp from the filter.
Pulp too wet and reduced • Try a slower juicing action. Remove stainless steel
juice extraction. mesh filter and thoroughly clean mesh with a nylon
brush. Rinse the filter basket with hot water. If the
fine mesh holes are blocked, soak the basket in
a solution of hot water with 10% lemon juice to
unblock the holes or wash in the dishwasher. This
will remove excess fiber build up (from fruit or
vegetables), which could be reducing the flow of
juice.
Juice leaks between the rim • Try a slower juicing action by pushing the Food
of the Juicer and Juice Pusher down slower.
Extractor Cover.
www.oster.com
SOLUTION
10
6/5/20 09:37 6/5/20 09:37