Switching On The Unit; Electrical Connection - Kärcher HD 600 Manual Del Usuario

English
Protection of the
environment, disposal
The packaging material can be
recycled. Please do not place the
packaging into the ordinary refu-
se for disposal, but arrange for
the proper recycling.
Old appliances contain valuable
materials that can be recycled.
Please arrange for the proper re-
cycling of old appliances. Batte-
ries, oil, and similar substances
must not enter the environment.
Please dispose of your old ap-
pliances using appropriate col-
lection systems.
Warranty
The warranty terms issued by our
authorised marketing company are valid in
every country. We remedy any fault in the
cleaner free of charge within the warranty
period providing the cause of the fault
proves to be a material or manufacturing
error.
The warranty only becomes operative
when your dealer has completed the reply
card accompanying the sale of the unit,
has stamped and signed it and you have
then sent the reply card to the marketing
company in your country.
Should you wish to call upon the guarantee,
please apply to your dealer or nearest
authorised Customer Service centre taking
along also the accessories and bill of sale.
16
Preparing the unit for use
Unpack the unit
– When unpacking the unit, check
the contents of the packaging. If there
has been any damage in transit inform
the dealer.
– Do not dispose of the packaging with
the household rubbish, hand it in at
the appropriate collection point for
recycling.
Check the oil level
Check the oil level in the oil reservoir.
Cut off the tip on the cover to the oil
reservoir.
Mount the accessories
Mount nozzle on the spray lance (see
markings on the top of the setting ring).
Mount spray lance on the handgun.

Switching on the unit

Electrical connection

The power must be connected by
an electrician in compliance with
IEC 60364.
It is recommended that the electrical
connection to this unit features either
a residual-current-operated circuit-
breaker which interrupts the mains
voltage if the residual current exceeds
a value of 30 mA during 30 ms, or an
earth tester.
Caution!
The voltage specified on the model
rating plate must correspond to the voltage
supplied.