Black and Decker BES720 Traducido De Las Instrucciones Originales página 11

Use saw blades designed to reduce the emitted noise,
u
Use only well sharpened saw blades, and
u
Use specifically designed noise-reduction saw blades.
u
Labels on tool
The following pictograms along with the date code are shown
on the tool:
Warning! To reduce the risk of injury, the
user must read the instruction manual.
Wear safety glasses or goggles
Wear ear protection
Wear a dust mask
This product is not to be used by children
under 16
Keep hands away from blade
Wear gloves when handling saw blades
Do not expose the appliance to rain or high
humidity.
Disconnect the mains plug if the cord
becomes damaged or entangled.
#
Electrical safety
This tool is double insulated; therefore no
earth wire is required. Always check that the
power supply corresponds to the voltage on
the rating plate.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised Stanley FatMax Service
Centre in order to avoid a hazard.
Voltage drops
Inrush currents cause short-time voltage drops. Under unfa-
vourable power supply conditions, other equipment may be
affected. If the system impedance of the power supply is lower
than 0.361, disturbances are unlikely to occur.
Using an extension cable
Always use an approved extension cable suitable for the
power input of this tool (see technical data). Before use,
inspect the extension cable for signs of damage, wear and
ageing. Replace the extension cable if damaged or defective.
When using a cable reel, always unwind the cable completely.
Use of an extension cable not suitable for the power input of
the tool or which is damaged or defective may result in a risk
of fire and electric shock.
Features
This tool includes some or all of the following features.
Caution! Read the
instruction manual
for the correct
adjustment and
locking procedure
for the Guard and
Riving knife.
Assembly
Assembling the leg stand (Fig. A, B & C)
Note:
be assembled one way.
(Original instructions)
1. Saw table
2. Blade guard
2a. Blade guard storage
3. Riving knife
4. Saw blade
4a. Saw blade storage
5. Rip fence
5a. Rip fence storage
6. Mitre gauge
6a. Mitre gauge storage
7. Dust bag
8. On/off switch
9. Leg stand
10. Bevel adjustment locking knob
11. Blade elevation handle
12. Leg stand locking knob
13. Blade tilting wheel
14. Locking handle for extension table
15. Locking handle for rip fence
16. Extension table
17. Spanner wrench X2
18. Guide rail
19. Push stick
20. Table insert
21. Overloaded protector
22. Leg stand level adjustor
23. Power cable
24. Power cable storage tabs
Open the box and lift the saw out.
u
Place the saw on a smooth, flat surface such as a
u
workbench or strong table.
The machine is delivered with the saw blade (4) set to
u
45 degrees. Reset to 0 degrees following the Setting the
blade angle instructions below
The leg stands have been designed so they can only
ENGLISH
11