Power Cord Connection - Gree GMV-ND22PL/B-T Manual Del Propietário

Multi Variable Air Conditioners Floor and Ceiling Type Indoor Unit
so that the single-core wire can be exposed.
2) Use a screwdriver to remove the terminal screw on the terminal board.
3) Use a plier to bend the end of single branch line until it forms a circle that has a similar size with the
screw.
4) Lead the screw across the circle of the single branch line and fix it on the wiring board.
2 Connection of Multi-twisted Wire(shown in Fig.5.1.2)
1) Use a wired stripper to strip away about 10mm of the insulation layer at the end of multi-twisted
wire.
2) Use a screwdriver to remove screw on the wiring board of air conditioner.
3) Use a round terminal fastener or a plier to securely fasten the round terminal with each core wire of
the multi-core wire.
4) Confirm each position of core wire on the round terminal and then use a screwdriver to tighten the
terminal screw.
Fig 5.1.1

5.2 Power Cord Connection

Note:
Power supply of each indoor unit must be from the same source.
Remark: The maximum number of indoor units that can be connected depends on the capacity of outdoor
unit. For specific details, please refer to the capacity configuration part.
1 For air conditioner that uses single-phase power
1) Remove the cover of electric box of indoor unit.
2) Lead the power cord across the rubber ring.
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
Fig 5.1.2
Fig 5.2
16