VALBERG WF 814 S566C Instrucciones De Uso página 5

B
Using the appliance
ΠRemove the cardboard box and styrofoam packing.
 Lift the washing machine and remove the base packaging. Make sure the small foam
triangle is removed together with the bottom packaging. If not, lay the unit down on its side
and remove it manually.
Ž Remove the tape securing the power supply cord and drain hose.
 Remove the inlet hose from the drum.
Remove the transport bolts
WARNING!
You must remove the transport bolts from the back side
before using the product.
1
ΠLoosen the 4 transport bolts with a spanner.
 Remove the bolts including the rubber parts and keep them for future use.
Ž Close the holes using the cover caps.
Levelling the washing machine
WARNING!
The lock nuts on all four feet must be screwed tightly against
the housing.
ΠLoosen the lock nut.
 Turn the foot until it reaches the floor.
Ž Adjust the legs and lock the nuts with a spanner. Make sure the machine is level and
steady.
2
6 EN
B
Using the appliance
Connect the water supply hose
WARNING!
To prevent leakage or water damage, follow the instructions
in this chapter
• Do not kink, crush or modify the water inlet hose.
Connect the water supply hose to the water inlet valve and a water tap with cold water as
indicated.
3
NOTE
Connect manually, do not use tools. Check if the connections
are tight.
Drain Hose
WARNING!
• Do not kink or stretch the drain hose.
• Position the drain hose properly, otherwise damage might
result or water leakage.
There are two ways to place the end of the drain hose:
Water
trough
ΠPut it into the water trough.
 Connect it to the branch drain pipe of the trough.
1
7 EN
2