CRC SmartWasher SW-23 Manual De Instrucciones página 13

7.1.2. Model SW-25
1. Remove the OzzyMat
lay it on the mat support grid located in the lowest
level in the sink. Make sure to lay the OzzyMat
white side up.
2. Place the false bottom in position in the sink.
3. Form the flexible nozzle to its desired shape and be
sure that the parts brush is inside the sink
4. DO NOT PLUG UNIT IN BEFORE ADDING
OZZY JUICE
®
5. At start up, carefully add ± 95 liter of OzzyJuice
the SmartWasher
®
directly into the sink.
6. Plug the unit into a 220 VAC GFCI electrical outlet
7. The SmartWasher
®
to heat up to its selected optimal temperature of
40°C (± 1°) or 46°C (± 1°). This temperature will be
maintained as long as the SmartWasher
in and full of OzzyJuice
the heater automatically shuts off)
SmartWasher
BIOREMEDIATING parts washing system
USER INSTRUCTION MANUAL
from its package, unfold it and
®
by slowly pouring the solution
will take approximately four hours
®
. (If the Add Fluid Light is on,
®
ORIGINAL INSTRUCTIONS
®
33075
Drain Basket 3 1/2"
Stainless steel
to
®
is plugged
®
33052
False Bottom With
Drain For Sink
32950
Multi-Layer OzzyMat
FL-4
33076
Mat Support Grid
page 13 of 720