CRC SmartWasher SW-23 Manual De Instrucciones página 27

9.1. Start Up
• Unpack the SmartWasher
• Install the equipment as described in par. 7.1 of this
user instruction
• Take away the basket and the OzzyMat
• Depending on the model, carefully add ± 60 or ± 95
liter of OzzyJuice
®
pouring the solution directly into the sink;
• Plug in the SmartWasher
(220 VAC);
• The "Add Fluid" sign should be out when enough
OzzyJuice has been added
®
• Please note that the heater will not operate if the
"Add Fluid" sign is illuminated.
• Your SmartWasher
a day,7 days a week in order to maintain the optimal
temperature;
• Depending on the OzzyJuice
your SmartWasher
®
maintain a fluid temperature between 40°C and 46°C
(± 1°C). This temperature provides the optimum
condition for effective cleaning and activity of Ozzy
microbes.
- If, after a reasonable warm-up period, the fluid
temperature seems too high or too low, please
refer to the troubleshooting part in chapter 11
of this instruction manual.
- The SmartWasher
fluid, called OzzyJuice
tion which provides a combination of excellent
cleaning characteristics, safety and nutrition for the
SmartWasher
BIOREMEDIATING parts washing system
USER INSTRUCTION MANUAL
;
®
;
®
to the SmartWasher
®
to the main power supple
®
should be plugged in 24 hours
®
solution shipped with
®
, the thermostat is factory-set to
uses a specially formulated
®
. This is a degreasing solu-
®
ORIGINAL INSTRUCTIONS
9. Operation
Ozzymicrobes. OzzyJuice
to-use containers of 20 litres.
- If the temperature falls below the recommend-
ed minimum temperature, the system will still
clean, but remediation of the hydrocarbons by the
Ozzy microbe colony will slow down. However,
the microbes will not die. The Ozzy colony will
, by slowly become more active when the fluid temperature
reaches the appropriate above mentioned tem-
perature range.
9.2. Operation
• The heater will not operate when the fluid level
becomes critically low. Lift the sink and check the
fluid level.
• To help monitor and maintain the proper fluid level,
the SmartWasher
light. When the "Add Fluid" sign illuminates on the
heater, the unit (including the heater) will automatically
switch off until OzzyJuice
• Adding OzzyJuice
the OzzyMat
litres) directly into the SmartWasher
Fluid" sign should go out when you have completed
the process.
• The "Add Fluid" sign will shut off and the heater will
automatically switch on again.
• Place the parts to be cleaned on the rinsing floor
of the equipment. The maximum load capacity is
indicated in the technical data in chapter 4 of this
user instruction manual.
is provided in ready-
®
is equipped with an "Add Fluid"
®
has been added.
®
: Take away the false bottom with
®
, and slowly pour a full container (of 20
®
page 27 of 720
®
sink. The "Add
®