7.1.4. Model SW-37
1. Remove the OzzyMat
it and lay it on the mat support grid located in
the lowest level in the sink. Make sure to lay the
OzzyMat
white side up.
®
2. Place the false bottom in position in the sink.
3. Form the flexible nozzle to its desired shape and be
sure that the parts brush is inside the sink
4. DO NOT PLUG UNIT IN BEFORE ADDING
OZZY JUICE
®
5. At start up, carefully add ± 95 liter of OzzyJuice
to the SmartWasher
directly into the sink.
6. Plug the unit into a 220 VAC GFCI electrical outlet
7. The SmartWasher
®
hours to heat up to its selected optimal temperature
of 40°C (± 1°) or 46°C (± 1°). This temperature
will be maintained as long as the SmartWasher
plugged in and full of OzzyJuice
light is on, the heater automatically shuts off.
SmartWasher
BIOREMEDIATING parts washing system
USER INSTRUCTION MANUAL
from its package, unfold
®
by slowly pouring the solution
®
will take approximately four
. If the "Add Fluid"
®
ORIGINAL INSTRUCTIONS
®
is
®
®
32981 Plastic basket
33047
False bottom
32950
Multi-Layer
OzzyMat FL-4
33076
Mat support grid
33075
Drain basket 3 1/2"
Stainless steel
page 21 of 720