CRC SmartWasher SW-23 Manual De Instrucciones página 25

7.2. Electrical installation and setup
• The SmartWasher
alternating current power supply network. The voltage
indicated on the type plate must correspond to the
voltage of the electrical source. (220 VAC / 50-60 Hz)
• The equipment may only be connected to an electric
supply that has been installed by a qualified electrician
in accordance with IEC 60364.
• Any electrical component box may only be opened
by an qualified electrician
• It is imperative to connect the equipment to the
electric power supply by means of the supplied plug.
The plug serves for the complete disconnection of the
equipment from the main power supply. Do not alter
the cable under any conditions. In case of damages
to that cable, do not repair this cable but substitute
by a new one.
• Check the power cable with mains plug for damage
before every use. If the power cable is damaged, have
it replaced immediately by your local CRC Distributor
or by a qualified electrician in order to avoid possible
hazards.
SmartWasher
BIOREMEDIATING parts washing system
USER INSTRUCTION MANUAL
may only be connected to an
®
ORIGINAL INSTRUCTIONS
• The equipment should be installed in the
neighbourhood of a normal 220VAC Ground Fault
Circuit Interrupter (GFCI) electrical outlet so that it
can be plugged in easily. The SmartWasher
the only item plugged into this circuit. The electrical
circuit should be protected by a 30 mA differential
switch.
• The use of an extension cable is authorized. If an
extension cable is used, make sure that this cable is not
damaged by running over, pinching, dragging or similar.
Protect this cable from heat, oil, sharp edges, ...
• The extension cable must have the cross section listed
in the circuit plan and be protected against spraying
water. The connection must not lie in water.
• Please use the power cable prescribed by the
manufacturer. The same is also applicable when you
replace the power cable. For type details see chapter
7.1 of this user instruction manual.
• If couplings of the power cable or extension cable are
replaced, the splash protection and the mechanical
tightness must be ensured. For connection values,
see type plate/technical data.
• Never touch the main power plug with wet hands.
®
should be
®
page 25 of 720