CRC SmartWasher SW-23 Manual De Instrucciones página 9

7.1. Mechanical installation and
setup
7.1.1. Model SW-23
1. Remove the OzzyMat
lay it on the mat support grid located in the lowest
level in the sink. Make sure to lay the OzzyMat
white side up.
2. Place the false bottom in position in the sink.
3. Form the flexible nozzle to its desired shape and be
sure that the parts brush is inside the sink
4. DO NOT PLUG UNIT IN BEFORE ADDING
OZZY JUICE
®
5. At start up, carefully add ± 60 liter of OzzyJuice
to the SmartWasher by slowly pouring the solution
directly into the sink.
6. Plug the unit into a 220 VAC GFCI electrical outlet
7. The SmartWasher will take approximately four hours
®
to heat up to its selected optimal temperature of
40°C (± 1°) or 46°C (± 1°). This temperature will be
maintained as long as the SmartWasher
and full of OzzyJuice
the heater automatically shuts off.
SmartWasher
BIOREMEDIATING parts washing system
USER INSTRUCTION MANUAL
7. Installation and setup
from its package, unfold it and
®
is plugged in
®
. If the "Add Fluid" light is on,
®
ORIGINAL INSTRUCTIONS
PARTS WASHER SETUP SW-23
®
®
®
32981
Plastic Basket
33046
False Bottom for SW-23
32950
Multi-Layer OzzyMat FL-4
33076
Mat support grid
page 9 of 720