CRC SmartWasher SW-23 Manual De Instrucciones página 30

10.2.3. Monthly
The OzzyMat traps sludge and dirt as small as 50 mi-
®
crons. It works effectively even when it appears dirty.
At some point, however, it will become saturated and
unable to pass fluid freely and should be changed. The
FL-4 multi-layer OzzyMat
being able to peel layers between mat changes.
To maintain the effectiveness and per-
formance of the OzzyJuice
replace the OzzyMat
®
OzzyMat FL-4 replacement
®
- Make sure the pump is not running
- Remove the false bottom from the sink
- Remove the last layer of the soiled OzzyMat
and set to one side of the filter support grid
- Remove a new OzzyMat
unfold the mat and lay it on top of the filter
support grid – white side up.
Wring any excess fluid from the old mat onto the new
OzzyMat . It is important to wring used OzzyMat
®
prior to disposal
Take the old, used OzzyMat
bag the new mat came in.
Return the false bottom to its proper position
Discard used OzzyMat
regulations.
SmartWasher
BIOREMEDIATING parts washing system
USER INSTRUCTION MANUAL
allows you the benefit of
®
, maintain or
®
, once a month.
from its poly bag,
®
and place into the poly
®
in accordance with your local
®
ORIGINAL INSTRUCTIONS
10.2.4. Yearly
We suggest to perform at least an annual maintenance.
Simple perform the annual maintenance described here
below:
- Pump out the fluid into a suitable container until
the machine is drained
- Unplug the SmartWasher
- Only pull out the lock pins prior to removing the sink
- Remove the sink from the base, inspect and re-
move any sludge that might have accumulated on
the bottom of the unit
- Clean the base with water to remove any debris
- Visually check the condition of the hoses, con-
nectors, etc.
- If everything appears to be in a good working
condition, reassemble the sink, poor the necessary
amount of OzzyJuice
®
install the false bottom with the OzzyMat
- Make sure that during the re-assembly, compo-
nents (e.g. hoses, ...) do not come in contact
with the heating element.
- Do not forget to put the safety pins back in place
- If you fail to maintain your SmartWasher
®
may still be able to save your fluid
- Add OzzyBooster
to bring your fluid back into conformity.
- If the fluid has developed an odour or is dis-
coloured, contact your local distributor.
®
®
in the SmartWasher
®
for an extra supply of microbes
®
page 30 of 720
, and
®
.
®
, you
®