Reset The Collar Receiver; Program The Collar Receiver For Two Orthree-Dog Operation - SportDOG SportHunter 800 Manual De Instrucciones

Mode
7
Continuous Correction with
- correction level set by knob
8
with no tone - correction level
is released there is
delay followed by tone, which
second delay, then tone is not
Note: In Mode 4, 6, 7 or 8, the "high" and "low" ends of reading on Intensity Dial are within the
level set by the Intensity Dial. For example, if the Intensity Dial is set to 4, the Upper Button will
deliver Stimulation lower than level 5, and the Lower Button will deliver Stimulation higher than
level 3, but the Upper Button will deliver stronger Stimulation than the Lower Button.
_____________________________________________________________

Reset the Collar Receiver

Step
6
To reset the Collar Receiver to work with a new Remote Transmitter or to reprogram a
new Collar Receiver to work with your existing Remote Transmitter:
1. Turn the Collar Receiver off.
2. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then
turn off after 4-5 seconds. If the On/Off Button is released too early, the Receiver
Indicator Light will begin fl ashing as normal. If this occurs, start over and repeat the
process.
3. After the Receiver Indicator Light has turned off, release the On/Off Button.
4. Press and hold the Upper Button on the Remote Transmitter until the Receiver
Indicator Light fl ashes 5 times. You may need to hold both units 0.5-1m from each
other before this occurs. Once the Receiver Indicator Light has fl ashed 5 times, the
Collar Receiver has been reset and will begin fl ashing as normal. If the Receiver
Indicator Light does not fl ash 5 times, start over and repeat the process.
_____________________________________________________________
Step Program the Collar Receiver for Two or
7
Three-Dog Operation
With the Transmitter set to Mode 5, 6, 7 or 8, SportDOG
set to respond to the upper, lower, or side Remote Transmitter buttons. SportDOG
Add-A-Dog
1. Program the Remote Transmitter to Mode 5, 6, 7 or 8.
2. Program the fi rst Collar Receiver.
All manuals and user guides at all-guides.com
UPPER BUTTON
FUNCTION
Dog 1
no tone
Dog 1
- Continuous Stimulation
set by knob - when button
1 / second
2
lasts for 1 second (if button
1
is pressed again before /
delivered).
® receiver(s) must be purchased to train additional dogs.
www.sportdog.com/international
LOWER BUTTON
FUNCTION
Dog 2
Continuous Correction with
no tone
- correction level set by knob
Dog 2
- Continuous Stimulation
with no tone - correction level
set by knob - when button
is released there is
delay followed by tone, which
lasts for 1 second (if button
is pressed again before
2
second delay, then tone is not
delivered).
SIDE BUTTON
FUNCTION
Dog 3
Continuous Correction
with no tone
- correction level set by
knob
Dog 3
- Continuous Stimulation
with no tone - correction
level set by knob - when
1 / second button is released there is
2
1
/ second delay followed
2
by tone, which lasts for
1
/ 1 second (if button is
2
pressed again before
second delay, then tone is
not delivered).
™
Collar Receivers can be
1 /
2
11