Maxi-Cosi AxissFix Manual De Instrucciones página 55

• Install the AxissFix in a rearward-facing position
when your child is between 61 up to 87 cm
length.
• You may install the AxissFix in a forward-facing
position when your child is from 76 up to 105 cm
lenght (older than 15 months). The maximum
occupant mass for which the carseat is intended
is 19 kg.
• Make sure that any luggage and other objects
liable to cause injuries in the event of a collision
shall be properly secure.
• Always cover the AxissFix when exposed to direct
sunlight in the car. Otherwise, the cover, metal
and plastic parts could become too hot for your
child's skin.
• Make sure the straps holding the carseat to the
vehicle should be tight.
WARNING:
When the car seat is installed on the front
passenger seat, you must switch off the front
passenger airbag if your child is sitting in a
rearward-facing position.
WARNING:
When the car seat is installed on the front
passenger seat, we recommand to switch off the
front passenger airbag if your child is sitting in a
front-facing position and place the passenger seat
in the rearmost position.
Baby in the AxissFix car seat :
• Never leave your child unattended.
• For your own safety and the one of your child
All manuals and user guides at all-guides.com
• Always secure your child with the 5-point harness.
• Ater putting the child in the car seat, ensure that
• Make sure you can fit no more than one finger
• Check to make sure the headrest is adjusted to
• Do not use the child restraint device without
• The temperature inside a vehicle may become
WARNING:
The Axissfix must be used rearward facing until
your child is over 15 months or measure more
than 87 cm.
always put the child in the car seat and fasten
him however short your journey may be.
Ensure that the lap straps is worn low down, so
that the pelvis is firmly engaged, shall be stressed.
the harness is sufficiently taught by pulling the
belt. Before every use, make sure the harness is
not damaged or twisted.
between the harnesses and your child (1cm). If
there is more space than 1 cm, tighten the
harness belt further.
the proper height.
the cover. Do not replace the seat cover with
any other than the one recommended by the
manufacturer, because it will have a direct effect
on the functioning of the car seat.
very high, particularly after a long period of
exposure to the sun. It is strongly recommended,
under such conditions, to cover the seat of the
car with a piece of material or something
equivalent to prevent the harness fixings, and in
particular the metal parts, from becoming hot
and burning the child.
EN
57