Diagnosis - Metrohm 774 Oven Sample Processor Manual De Instrucciones

5.11.7 &Diagnosis ...
5.11.7.1
5.11.7.2
5.11.7.3
5.11.7.4
5.11.7.5
5.11.7.6
774 Oven Sample Processor, Instrucciones para el uso
5.11 Description of the remote control commands
Diagnose.Init
Diagnose.Init.Select
RAM initialization. Sets all default values for the selected sub-branch. See
also 5.11.4.11.
&Diagnose.Init;$G triggers the initialization..
Diagnose.RamTest
Diagnose.LcdTest
Diagnose.ContrastTest
Diagnose.KeyTest
Diagnose.IoTest
Diagnose.RsTest
Diagnose.EbusTest
Diagnose.BeeperTest
Diagnose.RackcodeTest
Diagnose.FunctionTest
Diagnostic functions. These functions can be triggered with $G. They may
be stopped with $S.
.RamTest Working memory test
.LcdTest Display test
.ContrastTest Display contrast test
.KeyTest Displays key code and function of each key
.IoTest Remote interface test
.RsTest (This function is not applicable via RS232 interface)
.EbusTest External Bus interface test
.BeeperTest Test of the acoustic signal (only with
Config.Beeper"on", see 4.10.2.14)
.RackcodeTest Test of rack code recognition
.FunctionTest Metrohm internal test
Diagnose.SimulateKey
Key simulation (Key codes see 5.11.4.2).
Diagnose.InstrNo
Instrument number. This entry is not accessible via RS232 interface.
Diagnose.OvenTest
Diagnose.Adjust
Diagnose.MeasTest
.OvenTest Heater test.
.Adjust Adjustment of temperature and gas flow measurement.
.MeasTest Test of temperature measurement.
Diagnose.PowerOn
Simulation of 'Power on'.
$G
param, config,
setup, assembly, all
$G
$G, $S, $H
$G, $S
$G, $S
$G, $S
$G, $S
$G, $S
$G, $S
$G, $S
0, 1...6, 8...31
$G, $S
$G, $S
$G, $S
$G
127