Declaration Of Conformity - Worx WX529 Manual Del Usuario

TROUBLE SHOOTING
Symptom
Tool will not start when operating
the on/off switch.
Cutting depth is less than that
is set.
Blade spins or slips
Blade will not cut a straight line.
Blade kicks back when beginning
a cut
DECLARATION OF
CONFORMITY
We,
Positec Germany GmbH
Grüner Weg 10, 50825 Cologne, Germany
Declare that the product
Description Battery-powered circular saw
Type WX529 WX529.9 (5-designation of
machinery, representative of Saw)
Function Cutting various materials with a
rotating toothed blade
Complies with the following Directives:
2006/42/EC
2011/65/EU&(EU)2015/863
2014/30/EU
Standards conform to
EN 62841-1
EN 62841-2-5
EN 55014-1
EN 55014-2
Lithium-Ion cordless circular saw
Possible Causes
Battery pack not plugged in.
Battery pack is powered off.
Carbon brush has worn down
Sawdust accumulated at the
rear of the base.
Blade is not tightly engaged
with the spindle.
Blade is dull.
Blade is not mounted properly.
Saw is not being guided
properly.
Blade is not spinning fast
enough
The person authorized to compile the technical file,
Name
Address
Grüner Weg 10, 50825 Cologne, Germany
2020/05/19
Allen Ding
Deputy Chief Engineer, Testing & Certification
Positec Technology (China) Co., Ltd
18, Dongwang Road, Suzhou Industrial
Park, Jiangsu 215123, P . R. China
Possible Solution
Check to make sure battery pack is
connected well into a working outlet
Charging the battery.
Replace the carbon brush using a
qualified maintenance person.
Shake out sawdust. Consider
connecting a vacuum for dust
collection.
Remove the blade, and reassemble
it as described in SAW BLADE
ASSEMBLY AND REMOVING
section.
Mount a new, sharp blade on the saw.
Check that blade is properly mounted.
Use a parallel guide.
Allow the saw blade to reach full
speed prior to beginning a cut in the
material.
Marcel Filz
Positec Germany GmbH
13
EN